micro-uart cable:
1. Phone must be powered on.
2. Connect the phone to UART port.
3. Choose correct COM port in port settings
4. Press "Read info" button.
micro-USB cable:
1. Phone must be powered on.
2. Type *#7284# and choise phone usb.
3. Type *#197328640#, select: Common - Diag Config - USB diag.
4. Reboot phone.
5. Connect USB cable, install drivers.
6. Select diagnostic port in port settings.
7. Press "Read info" button.

1. Choose correct flash file(s).Check flashing options if needed (Re-partition, EFS clear, Boot update)
2. Power on phone in download mode (turn off phone, hold Volume Up + Volume Down + Power.)
3. Connect phone to PC, install drivers if needed.
4. Press "Flash" button.

micro-uart cable:
1. Phone must be powered on.
2. Connect the phone to UART port.
3. Choose correct COM port in port settings.
4. Press "Unlock" button.
micro-USB cable:
1. Phone must be powered on.
2. Type *#7284# and choise phone usb.
3. Type *#197328640#, select: Common - Diag Config - USB diag.
4. Reboot phone.
5. Connect USB cable, install drivers.
6. Select diagnostic port in port settings.
7. Press "Unlock" button.

micro-uart cable:
1. Phone must be powered on.
2. Connect the phone to UART port.
3. Choose correct COM port in port settings.
4. Press "Read codes" button.
micro-USB cable:
1. Phone must be powered on.
2. Type *#7284# and choise phone usb.
3. Type *#197328640#, select: Common - Diag Config - USB diag.
4. Reboot phone.
5. Connect USB cable, install drivers.
6. Select diagnostic port in port settings.
7. Press "Read codes" button.

micro-uart cable:
1. Phone must be powered on.
2. Connect the phone to UART port.
3. Choose correct COM port in port settings.
4. Choose dump option (Full NVM or NVM).
5. Press "Read" button.
micro-USB cable:
1. Phone must be powered on.
2. Type *#7284# and choise phone usb.
3. Type *#197328640#, select: Common - Diag Config - USB diag.
4. Reboot phone.
5. Connect USB cable, install drivers.
6. Select diagnostic port in port settings.
7. Choose dump option (Full NVM or NVM).
8. Press "Read" button.

micro-uart cable:
1. Phone must be powered on.
2. Connect the phone to UART port.
3. Choose correct COM port in port settings.
5. Press "Write" button, choose NVM file, press "OK".
micro-USB cable:
1. Phone must be powered on.
2. Type *#7284# and choise phone usb.
3. Type *#197328640#, select: Common - Diag Config - USB diag.
4. Reboot phone.
5. Connect USB cable, install drivers.
6. Select diagnostic port in port settings.
7. Press "Write" button, choose NVM file, press "OK".